Tuesday, February 23, 2010

Start saving money on fuel cost today with our HHO generators and by following these useful driving tips.

  • Curb road rage. Speeding, rapid acceleration (jackrabbit starts), and rapid braking can lower gas mileage by 33% at highway speeds. Drivers can save up to 90 gallons of gasoline, or up to $210, by driving sensibly on the highway. If you don't have a "lead foot," your savings may be closer to 10% at highway speeds – about $65
  • Drive sensibly. Around town, sensible driving can save 5% – up to 17 gallons of gasoline and up to $40.
  • Cut Miles. If you can cut your vehicle miles traveled by just 5% through combining trips, walking, biking, or taking public transportation, you can save up to $70 per year on gasoline costs. Walking and biking are good for your health too!
  • Choose the Right Vehicle. If you own more than one vehicle, drive the one that gets better gas mileage whenever possible. If you drive 12,500 miles a year, switching 10% of your trips from driving a vehicle that gets 20 mpg to one that gets 30 mpg will save you almost $50 per year.
  • Turn Down the Air. Operating the air conditioner on "Max" can reduce mpg by 5 – 25% compared to not using it.
  • It‘s a ”drag.“ Avoid carrying items on your vehicle‘s roof. A loaded roof rack or carrier increases weight and aerodynamic drag, which can cut mileage by 5%. Place items inside the trunk whenever possible to improve your fuel economy.
  • Ditch "junk in the trunk." An extra 100 pounds in the trunk cuts a typical vehicle‘s fuel economy by up to 2%. You can save up to 12 gallons of gasoline per year – almost $30 – by removing an extra 100 pounds of unneeded items from the trunk.
  • Decrease Your Speed. Speeding costs! Gas mileage usually decreases rapidly above 60 mph. Each five miles per hour over 60 mph is like paying an additional 24 cents per gallon for gas.
  • Avoid idling. Idling gets 0 mpg. Vehicles with larger engines typically waste even more gas while idling than vehicles with smaller engines.
  • Combine errands/trips. If you combine errands into one trip, you drive fewer miles and use less fuel. Several short trips taken from a cold start can use twice as much fuel as a longer, multipurpose trip when the engine is warmed up and efficient.
  • Use Overdrive Gear. If available, use your vehicle‘s overdrive gear to reduce engine speed, which will enable you to save gas and reduce engine wear.
  • Use Cruise Control. Cruise control cuts fuel consumption by maintaining a steady speed during highway driving.
  • Consider other transportation options. Investigate options for getting to work and other places – public transportation, carpooling, biking, walking, or ridesharing when possible. Drivers who switch to other alternatives to get to work might be able to get a vehicle insurance premium discount because typically rates are assigned based on how far you drive to work. The commuting discount applies at any time – while many other discounts apply only when buying a new vehicle.
  • Carpool. Using the average U.S. work commute of 12.1 miles, commuters could save about $180 a year by carpooling twice a week with two other people in a vehicle that gets 20.1 miles per gallon – assuming the three passengers share the cost of gas.
  • Motorcycling. Motorcycles average 56 mpg—and motor scooters do even better. For one person or even two, motorcycles or scooters clearly use far less energy than a vehicle with one or two people. If four people need to go somewhere, they are better off in a vehicle that gets 30 mpg than on two motorcycles that get 56 mpg.
  • Telecommute or Stagger Work Hours. If your employer permits, avoid sitting in traffic and wasting gas, especially during peak rush hours. A worker who telecommutes twice a week would save about $275 a year in gasoline costs.
  • Request the Right Rental. Request a vehicle that gets better fuel economy, and remember to fill up the tank before returning the vehicle to the rental company, which charges much higher gas prices – and perhaps even an extra gas surcharge.
  • Buy Smart. When buying a new or used vehicle, think high gas mileage. Check out the U.S. Department of Energy's Web site or look for a SmartWay© certified vehicle on EPA's Green Vehicle Guide for information on fuel-efficient vehicles.

Maintenance Tips

  • Inflate Your Tires. Keeping your tires properly inflated is simple and improves gas mileage by around 3%, saving up to 20 gallons of gasoline, or up to $45.
  • Tune up. Fixing a vehicle that is noticeably out of tune or has failed an emissions test can improve its gas mileage by an average of 4% – saving up to 25 gallons of gasoline and about $55. Fixing a faulty oxygen sensor can improve mileage by as much as 40% – saving up to 245 gallons of gasoline or up to $570.
  • Check and replace air filters regularly. Replacing a clogged or dirty air filter keeps impurities from damaging the inside of your engine – though in newer model vehicles it does not improve fuel efficiency.
  • Select the right oil. Using the manufacturer's recommended grade of motor oil can improve gas mileage by 1 to 2%, resulting in annual savings of up to $30. Motor oil that says "Energy Conserving" on the API performance symbol contains friction-reducing additives. Also, change your oil to extend the life of your vehicle and to save even more money. And remember to recycle used oil which, with proper controls, can be safely re-used as a fuel or re-refined back to a lube oil.

Money Saving Vacation Gas Tips

Whether your vacation plans include a road trip or flying then renting a vehicle, how you drive and maintain a vehicle can either increase or decrease a vehicle's fuel efficiency and your gas costs. You can start saving money on gas even before you are on the road with a little planning and basic maintenance tips.

  • Planning your vacation:
    • Choose the right vehicle. If you own more than one vehicle, drive the one that gets better gas mileage if possible.
    • Request the right rental. If you are renting a vehicle at your destination, request a vehicle that gets better fuel economy, and remember to fill up the tank before returning the vehicle to the rental company, which charges much higher gas prices – and perhaps even an extra gas surcharge.
    • Are we there yet? Getting lost while driving in unfamiliar areas could lead to an expensive waste of gas. Resources on the Drive $marter Challenge website can help your family print a customized vacation map that highlights low cost gas along your route.
    • Rise and shine! When possible drive during off-peak hours to reduce gas costs and stress by avoiding stop and go or bumper-to-bumper traffic conditions.
    • Consider other transportation options. Investigate options for getting around on your vacation— public transportation, biking, walking, or ridesharing when possible.
    • Motorcycling. Motorcycles average 56 mph—and motor scooters do even better. For one person or even two, motorcycles or scooters clearly use far less energy than a vehicle with one or two people. If four people need to go somewhere, they are better off in a vehicle that gets 30 mpg than on two motorcycles that get 56 mpg.
  • Before You Leave: Maintenance Tips
    • Inflate your tires. Keeping your tires properly inflated is simple and improves gas mileage by around 3%.
    • Select the right oil. Using the manufacturer’s recommended grade of motor oil, including re-refined motor oil, improves gas mileage by 1 to 2%, resulting in annual savings of up to $30. Motor oil that says “Energy Conserving” on the API performance symbol contains friction-reducing additives. Also, change your oil as recommended to extend the life of your vehicle and remember to recycle the used oil which can be re-refined, saving even more energy.
    • Tune up. Fixing a vehicle that is noticeably out of tune or has failed an emissions test can improve its gas mileage by an average of 4%.
  • While On The Road: Driving Tips
    • Decrease your speed. Speeding costs! Gas mileage usually decreases rapidly above 60 mph.
    • Use cruise control on highways. Cruise control cuts fuel consumption by maintaining a steady speed during highway driving.
    • It’s a “drag.” Avoid carrying items on your vehicle’s roof. A loaded roof rack or carrier increases weight and aerodynamic drag, which can cut mileage by 5%. Place items inside the trunk whenever possible to improve your fuel economy.
    • Turn down the air. Operating the air conditioner on "Max" can reduce mpg by 5 – 25% compared to not using it.
    • Avoid idling. which gets 0 mpg. Vehicles with larger engines typically waste even more gas while idling than vehicles with smaller engines.

Friday, February 5, 2010

Secret of Titanium Drycell

Not knocking stainless steel - We believes the material was a good start towards well designed HHO generators - but the issues with current HHO generators: corrosion, electrical resistance, excessive heat and the problem of leeching hexavalent chromium, are non-existent with Titanium units.

Whats so special about Titanium?


These new Titanium Substrate HHO Cells produce a more pure form of HHO gas. Also, unlike Stainless Steel, Titanium will not leach hexavalent chromium during electrolysis, which has been a major concern for HHO enthusiasts from the beginning.

Chromium ions in the HHO gas of Stainless Steel act to accelerate the decay of orthohydrogen to para-hydrogen. Orthohydrogen is 4x more reactive than para-hydrogen. Titanium cells make no chromium ions or other ions. That is why the HHO gas from a Titanium Cell is more reactive.

Yes of course we knew that there are people using the MMO coating Titanium plates,however in a Titanium HHO Cell, the Cathode CANNOT be MMO coated! The cathode must remain bare titanium only, the coating will come off during electrolysis. Only the anode requires MMO Titanium Substrate material.However the coating may still come out from anode after long time of usage,yes it last for long time but still come out. This is the reason why people have experienced problems with their MMO Titanium HHO Cells having a very short life span especially there using high Amp.

And there is few information about that Pure titanium if not MMO coating CANNOT use as anode. Yes! The pure titanium plates cannot use as the anode ,IT block current.You were never believe it until you try it .WHY? This was because of the oxidization on the anode .Anode produce Oxygen when use the Titanium the a thin layer of Titanium Oxide were built up due to the oxidization.And this Titanium Oxide were block the current .The Amp drop immediate to nun just after few seconds we start the drycell.

At the end of days we decide to use expensive Nickel Super Alloy as the anode & neutral plates & the Pure Titanium for the cathode .

New Titanium Pro H2 EX cells include: no metal breakdown, which means the water stays perfectly clear, and the units seem to take less HHO gas to get the same results as a standard stainless steel cell using larger volumes.